Your cart is empty.
Your cart is empty.Product Description
Designed to slide into T-slot tracks on machine tool tables, add clamps to a fixture without tearing down existing clamps.
Your beloved item will receive better protection, allowing you to securely screw in the screws with peace of mind.
1018 Steel T-Slot Nut, Black Oxide Finish, Excellent weldability and offers a great balance of toughness, strength and ductility.
1/2”-13 Threads, Base Size (In.) 1"x 1" , Height:0.6"
Danise
August 2, 2025
Works the way there supposed to.
Wayne Berry
May 2, 2025
You will have to re-tap these; the threading is very poor and very shallow. I am not sure they are harden steel, they feel like mild steel.
MB
April 12, 2025
These are priced right, but you will have to retap them. They will not hold the stated bolt (1/2 13) for more than a turn. Far too little to set your vice in. I've spent too much time getting these right and believe the threads may not be as advertised (1/2 13). It's cheap enough that I would probably get again. But if a better name branded solution had been in stock, I definitely would have just gone with that and avoid the hassle.
brown dog
March 17, 2025
they do what they were designed to do
Себульба
March 11, 2025
They fit a normal Bridgeport/Hartford. They fit most threaded hold down rods. They all have large burrs and they are fully through drilled and threaded.
Bill
March 8, 2025
Poor quality machining. Threads had galling.
PJS Montana
January 5, 2025
Chinese POS. Nuts are plug tapped and will only accept about 3/8" of bolt threads. Plan on drilling all the way through and tapping youself.
Wesley
December 15, 2024
These appear to be well made T-Slot nuts but be careful and make sure that they will fit in your track. The information on the website shows the dimensions so I would recommend removing a nut from the T-Track and compare the dimensions since all tracks are not the same. Some might have the right slot width, but not be deep enough for these nuts.overall good quality.
Recommended Products